From: Frank (ocsic@web.de)
Date: Sat Jan 06 2007 - 14:22:36 ART
Scott Morris schrieb:
Hello Scott,
is it possible to search with control-f in the documentation? Would like
to keep my last
brain cells. Hope i can. Thanks in advance.
Frank
> I'd probably look on the DocCD under the Command Reference... Perhaps going
> to the IP Routing Protocols section and looking at EIGRP Commands.
>
> Perhaps a Ctrl-F for "hop" or "hop count" would help things out there? :)
>
> http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r
> /rte_eih.htm#wp1000064
>
> Sometimes it good to figure out what keywords are important to help you
> search for things. Nobody will ever memorize all of the commands. Even
> after all these years, I still look things up (most likely 'cause I killed
> too many brain cells at an earlier age, but that's a different story!
> (grin))
>
> HTH,
>
>
> Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
> #153, CISSP, et al.
> CCSI/JNCI-M/JNCI-J
> IPexpert VP - Curriculum Development
> IPexpert Sr. Technical Instructor
> smorris@ipexpert.com
> http://www.ipexpert.com
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Bit
> Gossip
> Sent: Saturday, January 06, 2007 10:39 AM
> To: groupstudy
> Subject: EIGRP hop count
>
> Hi group,
> is there any way to manipulate hop count in eigrp?
> I noticed that offset-list manipulates the composite metric but NOT
> hop-count!
> Thanks,
> Luca
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:55 ART