From: Keith Bizzell (mkbcoolman@gmail.com)
Date: Sat Dec 16 2006 - 08:05:43 ART
Thanks Kemal!
On 12/16/06, Kemal YILDIRIM <kemalhy@gmail.com> wrote:
>
> Hello Keith,
> This has been discussed some time ago, There were different apporaches by
> different gurus.
> Have a look at the below links
>
> http://www.groupstudy.com/archives/ccielab/200604/msg00083.html
>
> http://www.groupstudy.com/archives/ccielab/200608/msg01252.html
>
>
> HTH,
> Kemal
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Keith Bizzell
> Sent: 16 Aral}k 2006 Cumartesi 11:56
> To: Cisco certification
> Subject: IE Core 3 section 4.5 OSPF virtual link
>
> I'm seeing something strange with the virtual link. I can get it to work,
> I
> just cant explain why. The is no Area 0 defined in the topology, and the
> lab requires you to build a virtual-link between R3 and R1. I build this
> out on using the loopback addresses, but it will not work until I assign
> the
> loopback of R3 to area 0. After the virtual link is establised, I can
> remove the loopback from Area 0, and everything still works
> fine. Why? I'm
> uncomfortable with this solution on a lab, since I don't think this
> configuration would work on a reboot.
>
> Thanks,
> Keith
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:38 ART