From: Kemal YILDIRIM (kemalhy@gmail.com)
Date: Sat Dec 16 2006 - 07:31:19 ART
Hello Keith,
This has been discussed some time ago, There were different apporaches by
different gurus.
Have a look at the below links
http://www.groupstudy.com/archives/ccielab/200604/msg00083.html
http://www.groupstudy.com/archives/ccielab/200608/msg01252.html
HTH,
Kemal
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Keith Bizzell
Sent: 16 Aral}k 2006 Cumartesi 11:56
To: Cisco certification
Subject: IE Core 3 section 4.5 OSPF virtual link
I'm seeing something strange with the virtual link. I can get it to work, I
just cant explain why. The is no Area 0 defined in the topology, and the
lab requires you to build a virtual-link between R3 and R1. I build this
out on using the loopback addresses, but it will not work until I assign the
loopback of R3 to area 0. After the virtual link is establised, I can
remove the loopback from Area 0, and everything still works fine. Why? I'm
uncomfortable with this solution on a lab, since I don't think this
configuration would work on a reboot.
Thanks,
Keith
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:38 ART