From: Jojo jojo (barrerj1@hotmail.com)
Date: Tue Dec 05 2006 - 15:10:32 ART
You can use the below config
interface FastEthernet0/1
switchport mode access
switchport voice vlan 100
srr-queue bandwidth share 10 10 60 20
srr-queue bandwidth shape 10 0 0 0
priority-queue out
mls qos trust device cisco-phone
mls qos trust cos
auto qos voip cisco-phone
no mdix auto
spanning-tree portfast
hth
JoJo
>From: "Colm O'Leary" <Colm.O'Leary@anpost.ie>
>Reply-To: "Colm O'Leary" <Colm.O'Leary@anpost.ie>
>To: <ccielab@groupstudy.com>
>Subject: 3560 to Cisco IP Phone
>Date: Tue, 5 Dec 2006 15:51:21 -0000
>
>Group,
> Should the switchport connected to a Cisco IP Phone be configured as
>a trunk. The 3550 is set to dynamic desirable but the 3560 is set to
>dynamic auto. However if I issue the macro cisco-phone on the interface,
>it is configured statically as an access port.
>
>Confused?
>
>Colm
>
>*****************************************************************************
>****
>This e-mail and its attachments, is confidential and is intended for the
>addressee(s) only. If you are not the intended recipient, disclosure,
>distribution or any action taken in reliance on it is prohibited and may be
>unlawful. Please note that any information expressed in this message or its
>attachments is not given or endorsed by An Post unless otherwise indicated
>by
>an authorised representative independently of this message. An Post does
>not
>accept responsibility for the contents of this message and although it has
>been scanned for viruses An Post will not accept responsibility for any
>damage
>caused as a result of a virus being passed on.
>*****************************************************************************
>****
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:36 ART