From: CharlesB (cbalik@adelphia.net)
Date: Sat Dec 02 2006 - 17:48:29 ART
As far as I know, the default route feature is built in the ODR process.
Spoke
interface ether0
ip add 1.1.1.1 255.255.255.0
cdp enable
Hub
interface ether0
ip add 1.1.1.2 255.255.255.0
cdp enable
router odr
netw 1.1.1.0
This should make spoke to learn default from Hub, and Hub to learn Spoke's
connected routes, I believe.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Rodrigo Cesine Soave
Sent: Saturday, December 02, 2006 12:18 PM
To: ccielab@groupstudy.com
Subject: ODR default Routing
Hi everyone,
I was trying to find the feauture mentioned on the ODR Q&A document, but I
couldn4t.
Has everyone know about how send a default routing in a ODR environment from
the Hub to the spokes without using static routes or ip default-gateway on
the
spokes?
I did not find any new feature on the cisco web page.
Tks in advance.
Check below the document:
Do I need to configure a static default route in spoke routers?
A. You can configure a static default route in spoke routers only if you
are
using a Cisco IOS Software release earlier than 12.0.5T. In Cisco IOS
Software
Release 12.0.5T and later, there is a new feature that sends an automatic
default route to spokes from the hub.
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:36 ART