From: Curt Girardin (curt.girardin@chicos.com)
Date: Sat Dec 02 2006 - 17:50:30 ART
I believe in the later IOS releases (see below), the default route is
automatically installed (on the spoke) as long as there is no other
routing protocols (or static routes) installed on the spoke router.
HTH,
Curt
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Rodrigo Cesine Soave
Sent: Saturday, December 02, 2006 3:18 PM
To: ccielab@groupstudy.com
Subject: ODR default Routing
Hi everyone,
I was trying to find the feauture mentioned on the ODR Q&A document, but
I
couldn4t.
Has everyone know about how send a default routing in a ODR environment
from
the Hub to the spokes without using static routes or ip default-gateway
on the
spokes?
I did not find any new feature on the cisco web page.
Tks in advance.
Check below the document:
Do I need to configure a static default route in spoke routers?
A. You can configure a static default route in spoke routers only if
you are
using a Cisco IOS Software release earlier than 12.0.5T. In Cisco IOS
Software
Release 12.0.5T and later, there is a new feature that sends an
automatic
default route to spokes from the hub.
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:36 ART