From: Michael Stout (michaelgstout@hotmail.com)
Date: Sat Dec 02 2006 - 17:41:25 ART
You should not have to configure the spoke or the hub with statics.
hostname hub
CDP run
!
router odr
net w.x.y.z
end
hostname spoke
CDP run
router odr
end
If you are running ODR over a ethernet segment you must configure the
switch to pass CDP between routers.
if you are running it over serial interface you must trun on cdp on the
serial interfaces
if you are running it over frame you'll have to get cdp throug the frame
cloud.
If you speed up cdp, you won't have to wait as long for results.
You should see the default on your spoke.
--------------------------------------------------------------------
From: "Rodrigo Cesine Soave" <rcesine@terra.com.br>
Reply-To: "Rodrigo Cesine Soave" <rcesine@terra.com.br>
To: <ccielab@groupstudy.com>
Subject: ODR default Routing
Date: Sat, 2 Dec 2006 18:17:48 -0200
Hi everyone,
I was trying to find the feauture mentioned on the ODR Q&A document,
but I
couldn4t.
Has everyone know about how send a default routing in a ODR
environment from
the Hub to the spokes without using static routes or ip
default-gateway on the
spokes?
I did not find any new feature on the cisco web page.
Tks in advance.
Check below the document:
Do I need to configure a static default route in spoke routers?
A. You can configure a static default route in spoke routers only if
you are
using a Cisco IOS Software release earlier than 12.0.5T. In Cisco IOS
Software
Release 12.0.5T and later, there is a new feature that sends an
automatic
default route to spokes from the hub.
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
------------------------------------------------------------------------
All-in-one security and maintenance for your PC. Get a free 90-day
trial!
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:36 ART