From: Tony Schaffran (groupstudy@cconlinelabs.com)
Date: Sun Nov 19 2006 - 21:05:58 ART
Actually, an Inactive PVC typically indicates a problem with the config on
the other side.
Can you provide the config for the remote router that DLCI 403 is connecting
to?
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Nisar, Munsar
Sent: Sunday, November 19, 2006 2:01 PM
To: mzuo@ixiacom.com; ccielab@groupstudy.com
Subject: Re: need help with Frame Relay PVC problem
First off, why do you think you need to have "frame interface-dlci" command
on a physical interface? Secondly, I would check frame relay switch to
ensure that it is configured correctly. Thx.
-----Original Message-----
From: nobody@groupstudy.com <nobody@groupstudy.com>
To: ccielab@groupstudy.com <ccielab@groupstudy.com>
Sent: Sun Nov 19 13:36:17 2006
Subject: need help with Frame Relay PVC problem
Hi Group,
I see the following on my router:
R4(config-if)#do sh fram pvc | in DLCI
DLCI = 401, DLCI USAGE = UNUSED, PVC STATUS = INACTIVE, INTERFACE =
Serial0/0
DLCI = 402, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE =
Serial0/0
DLCI = 403, DLCI USAGE = LOCAL, PVC STATUS = INACTIVE, INTERFACE =
Serial0/0
DLCI = 405, DLCI USAGE = UNUSED, PVC STATUS = ACTIVE, INTERFACE =
Serial0/0
DLCI = 413, DLCI USAGE = UNUSED, PVC STATUS = INACTIVE, INTERFACE =
Serial0/0
R4(config-if)#do sh run int s0/0
Building configuration...
Current configuration : 238 bytes
!
interface Serial0/0
ip address 154.1.0.4 255.255.255.0
encapsulation frame-relay
no arp frame-relay
frame-relay map ip 154.1.0.3 403
frame-relay map ip 154.1.0.5 403
frame-relay interface-dlci 403
no frame-relay inverse-arp
end
R4(config-if)#
Is there any way I can find out why PVC 403 is inactive?
Thanks a lot
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:47 ART