From: srdja blagojevic (srdja1@pexim.co.yu)
Date: Fri Nov 17 2006 - 19:51:12 ART
You probably have virtual link configuration on the same ospf process.
Remove virtual link config, then first add neighbor statement, then put back
virtual link config and it will work fine (until next reload).
Search the archive, this was discussed couple of times. It is a known bug.
hth,
Srdja
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
2006ie@gmail.com
Sent: Friday, November 17, 2006 17:34
To: ccielab@groupstudy.com
Subject: Possible GOTCHA or MY ROUTERS HATE ME
Hey guys has anyone in the group seen this problem
Cisco 3640 (R4700) processor (revision 0x00) with 125952K/5120K bytes of
memory.
Processor board ID 26758289
R4700 CPU at 100MHz, Implementation 33, Rev 1.0
1 Ethernet interface
1 Serial interface
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of NVRAM.
32768K bytes of processor board System flash (Read/Write)
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
*When I reboot the router it removes my neighbor commands and gives the
above alert so the routers across the frame never form adjacency after the
reboot.*
**
*I added ip ospf network non-broadcast under the interface the router still
remove the neighbor command after the reboot.*
**
*I am runinng IOS version 12.4*
**
*Any suggestion would be most helpful*
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:47 ART