From: Alexei Monastyrnyi (alexeim@orcsoftware.com)
Date: Fri Nov 17 2006 - 19:16:42 ART
Bugid=CSCse72792
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCse72792&cco_pr
you can check GS archives for details
2006ie@gmail.com wrote:
> Hey guys has anyone in the group seen this problem
>
>
> Cisco 3640 (R4700) processor (revision 0x00) with 125952K/5120K bytes of
> memory.
> Processor board ID 26758289
> R4700 CPU at 100MHz, Implementation 33, Rev 1.0
> 1 Ethernet interface
> 1 Serial interface
> DRAM configuration is 64 bits wide with parity disabled.
> 125K bytes of NVRAM.
> 32768K bytes of processor board System flash (Read/Write)
>
> OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
> networks
> OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
> networks
>
>
> *When I reboot the router it removes my neighbor commands and gives the
> above alert so the routers across the frame never form adjacency after the
> reboot.*
> **
> *I added ip ospf network non-broadcast under the interface the router still
> remove the neighbor command after the reboot.*
> **
> *I am runinng IOS version 12.4*
> **
> *Any suggestion would be most helpful*
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:47 ART