From: 2006ie@gmail.com
Date: Fri Nov 17 2006 - 13:33:58 ART
Hey guys has anyone in the group seen this problem
Cisco 3640 (R4700) processor (revision 0x00) with 125952K/5120K bytes of
memory.
Processor board ID 26758289
R4700 CPU at 100MHz, Implementation 33, Rev 1.0
1 Ethernet interface
1 Serial interface
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of NVRAM.
32768K bytes of processor board System flash (Read/Write)
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
*When I reboot the router it removes my neighbor commands and gives the
above alert so the routers across the frame never form adjacency after the
reboot.*
**
*I added ip ospf network non-broadcast under the interface the router still
remove the neighbor command after the reboot.*
**
*I am runinng IOS version 12.4*
**
*Any suggestion would be most helpful*
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:47 ART