From: Alexei Monastyrnyi (alexeim@orcsoftware.com)
Date: Wed Nov 15 2006 - 05:52:41 ART
Hi.
Since etherchannel will load-balance on source and/or destination
IP/MAC, you'll never get 300 mbps per specific host pair. Here it works
not like MLPPP aggregation.
To test you may push bulky traffic from three source hosts to one
destination and tune load-balancing accordingly, then check TX/RX load
on channel member interfaces.
HTH
A.
Yoshe Rionando wrote:
> Hi Folks,
> How to verify speed of etherchannel. For example if i configure 3 port
> fastethernet to etherchannel, how can i verify that speed is 300 mbps?
>
>
> Yoshe Rionando Y.
> PT. Swadharma Duta Data
> Network & System Engineering Dept.
> Senior Network Engineer
> phone : 62 21 8318881
> fax : 62 21 8297293
> mobile : 62 8159084895
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:47 ART