From: Josh Wisman (jwisman@gmail.com)
Date: Sun Nov 12 2006 - 18:42:46 ART
Hello everyone. I have a problem I can't figure out. Why can't I add the "no
frame-relay inverse-arp" command to a point to point sub interface. It
accepts the command but it never shows up in the running config. If I put it
on the main interface it will take it and it shows up there... Here is my
running config and show ver. I am using dynamips BTW
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname r1
!
boot-start-marker
boot-end-marker
!
logging console alerts
!
no aaa new-model
memory-size iomem 5
!
!
ip cef
!
interface Serial1/0
no ip address <-------------------- I can insert it here and it will show
up
encapsulation frame-relay
shutdown
serial restart-delay 0
!
interface Serial1/0.1 point-to-point
ip address 121.1.12.1 255.255.255.0
frame-relay interface-dlci 102
!
interface Serial1/0.3 point-to-point
ip address 121.1.13.1 255.255.255.0 <---------------------Trying to insert
it below this line...
frame-relay interface-dlci 103
!
interface Serial1/0.4 point-to-point
ip address 121.1.14.1 255.255.255.0
frame-relay interface-dlci 104
!
interface Serial1/1
no ip address
shutdown
serial restart-delay 0
!
interface Serial1/2
no ip address
shutdown
serial restart-delay 0
!
interface Serial1/3
no ip address
shutdown
serial restart-delay 0
!
ip http server
!
!
!
!
!
!
control-plane
!
!
!
!
!
!
!
!
!
line con 0
exec-timeout 60 0
line aux 0
line vty 0 4
!
!
end
r1#show ver
Cisco IOS Software, 3600 Software (C3640-JS-M), Version 12.4(10a), RELEASE
SOFTW ARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Wed 11-Oct-06 20:52 by prod_rel_team
ROM: ROMMON Emulation Microcode
ROM: 3600 Software (C3640-JS-M), Version 12.4(10a), RELEASE SOFTWARE (fc2)
r1 uptime is 30 minutes
System returned to ROM by unknown reload cause - suspect
boot_data[BOOT_COUNT] 0 x0, BOOT_COUNT 0, BOOTDATA 19
System image file is "tftp://255.255.255.255/unknown"
Cisco 3640 (R4700) processor (revision 0xFF) with 124928K/6144K bytes of
memory.
Processor board ID 00000000
R4700 CPU at 100MHz, Implementation 33, Rev 1.2
4 Serial interfaces
DRAM configuration is 64 bits wide with parity enabled.
125K bytes of NVRAM.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x40 (will be 0xFFBF at next reload)
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:46 ART