From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Thu Oct 19 2006 - 15:17:49 ART
This is as per the RFC. The point-to-multipoint network type does not advertise out the network itself. It only advertises out the /32's. P2M is the only network type other than loopback that does this. If you mix P2P and P2M you'll have some /32's advertised by the P2M interfaces and a /24 (or whatever subnet mask is used) advertised by the P2P interfaces.
HTH,
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Noor Yousuf
Sent: Thursday, October 19, 2006 9:51 AM
To: ccielab@groupstudy.com
Subject: OSPF Multipoint issue
Hi,
I have a scenario like this
R1 (multipoint) - R3 (PTPwithR3 and spokewithR5) - R5 (HUB)
Lab says change the hello time on R3 to make it work with PTP.
But when I see the route on R5, I actually see the interface IP of the
R1 multipoint interface/32 as well as the network/24
As soon as I change the network type to PTP on R3 the /32 route
disappeared and I see only network/24 route.
Any ideas
Thanks
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:06 ART