From: Melwani, Manoj J (melwanim@citigroup.com)
Date: Wed Sep 20 2006 - 18:02:56 ART
Reflector Port should be a port that is not being used. Pick any port on the switch that is not being used.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
xprtofnet
Sent: Wednesday, September 20, 2006 2:51 PM
To: ccielab
Subject: RSPAN
Folks,
source---S1===trunk===S2---Sniffer
if i configure the RSPAN and assign the reflector port
to be the trunk port as above from source switch the
trunk goes down. How do we fix this ? F0/13 is a trunk
port.
my config is as follows:
S1
!
monitor session 1 source interface Fa0/1
monitor session 1 destination remote vlan 901
reflector-port Fa0/13
!
S2
!
monitor session 1 destination interface Fa0/1
monitor session 1 source remote vlan 901
!
Any inputs are welcome,
Thank you,
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:41 ART