From: Thunai Selvam \(thunai\) (thunai@cisco.com)
Date: Sun Aug 06 2006 - 02:50:54 ART
Hi
I hope the session id does not matter for the SPAN Config.. Let me
try that as well.
Regds
Thunai
________________________________
From: Yakov Shtoots [mailto:yakovz@gmail.com]
Sent: Saturday, August 05, 2006 11:11 PM
To: Thunai Selvam (thunai)
Subject: Re: RSPAN & IDS
on cat 1
change session 1 to be sourced with , remote vlan 500 and destionation
should be the port connected to sensin port on the ids
and change session 2 to be sourced with vlan 114 and destinatin is
remote vlan 500
On 8/5/06, Thunai Selvam (thunai) <thunai@cisco.com> wrote:
Hi all
I have following scenario
R4- (vlan 114)----(cat1)---Trunk-(dot1q all vlans
)---(cat2)-----(vlan114)-----R1
&
R2 --- (vlan 100)---(cat1)--Trunk (dot1q all
vlan)---(cat2)----(vlan
114)---R1
(Both r4 and r2 are connected to Cat1 with vlan 114 and Vlan100
respectively )
Senor Sensing interface on Cat1 Fa 0/18
Cat1
config t
vlan 500
remote-span
monitor sess 1 source vlan 114 , 100 rx
monitor sess 1 dest remote vlan 500 reflector fa 0/13
monitor ses 2 source remote vlan 500
monitor ses 2 dest inter fa 0/18
Cat 2
monitor ses 1 source vlan 114 rx
monitor ses 1 dest remo vlan 500 reflect fa 0/13
I am able to see the traffic from r1 ( vlan114 ) , however i am
not able
to see the traffic to R4 and R2 Routers on the IEV. is there
any thing
wrong in this config
Let me know your inputs.
Regds
Thunai
-- Yakov Shtoots, CCNP, CCSP/INFOSEC.Mobile: + 972-54-2110107
E-mail: yakovz@yakovz.net
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:56 ART