RSPAN & IDS

From: Thunai Selvam \(thunai\) (thunai@cisco.com)
Date: Sat Aug 05 2006 - 14:01:28 ART

• Next message: nikolai: "Re: Multicast on Switches"
• Previous message: Aamir Aziz: "Multicast on Switches"
• Next in thread: Thunai Selvam \(thunai\): "RE: RSPAN & IDS"
• Maybe reply: Thunai Selvam \(thunai\): "RE: RSPAN & IDS"
• Maybe reply: Thunai Selvam \(thunai\): "RE: RSPAN & IDS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi all
   I have following scenario

R4- (vlan 114)----(cat1)---Trunk-(dot1q all vlans
)---(cat2)-----(vlan114)-----R1
&
R2 --- (vlan 100)---(cat1)--Trunk (dot1q all vlan)---(cat2)----(vlan
114)---R1

(Both r4 and r2 are connected to Cat1 with vlan 114 and Vlan100
respectively )

Senor Sensing interface on Cat1 Fa 0/18

Cat1
config t
vlan 500
remote-span

monitor sess 1 source vlan 114 , 100 rx
monitor sess 1 dest remote vlan 500 reflector fa 0/13
monitor ses 2 source remote vlan 500
monitor ses 2 dest inter fa 0/18

Cat 2

monitor ses 1 source vlan 114 rx
monitor ses 1 dest remo vlan 500 reflect fa 0/13

I am able to see the traffic from r1 ( vlan114 ) , however i am not able
to see the traffic to R4 and R2 Routers on the IEV. is there any thing
wrong in this config

Let me know your inputs.

Regds
Thunai

• Next message: nikolai: "Re: Multicast on Switches"
• Previous message: Aamir Aziz: "Multicast on Switches"
• Next in thread: Thunai Selvam \(thunai\): "RE: RSPAN & IDS"
• Maybe reply: Thunai Selvam \(thunai\): "RE: RSPAN & IDS"
• Maybe reply: Thunai Selvam \(thunai\): "RE: RSPAN & IDS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:56 ART