ospf neighbor command

From: ELDHO PAUL (cciein2006@gmail.com)
Date: Fri Aug 04 2006 - 12:46:45 ART

• Next message: Melwani, Manoj J: "RE: ospf neighbor command"
• Previous message: Yadav Satish: "RE: BGP aggregate address"
• Next in thread: Melwani, Manoj J: "RE: ospf neighbor command"
• Maybe reply: Melwani, Manoj J: "RE: ospf neighbor command"
• Maybe reply: spycharlies@hotmail.com: "RE: ospf neighbor command"
• Maybe reply: Victor Cappuccio: "RE: ospf neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi,

I changed the interface type of my ethernet interface to non broadcast using
the command ip ospf network non-broadcast.
Then I tried to configure neighbor with the neighboring router through this
interface using the command
neighbor 183.1.5.5
But it displays a message "OSPF: Neighbor command is allowed only on NBMA
and point-to-multipoint networks"

When i say show ip ospf int eth0/0
it shows the interface type as NON_BROADCAST.

Is it an expected behaviour?

Please advice.

Regards,
Eldho.

• Next message: Melwani, Manoj J: "RE: ospf neighbor command"
• Previous message: Yadav Satish: "RE: BGP aggregate address"
• Next in thread: Melwani, Manoj J: "RE: ospf neighbor command"
• Maybe reply: Melwani, Manoj J: "RE: ospf neighbor command"
• Maybe reply: spycharlies@hotmail.com: "RE: ospf neighbor command"
• Maybe reply: Victor Cappuccio: "RE: ospf neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:56 ART