RE: ospf neighbor command

From: Melwani, Manoj J (melwanim@citigroup.com)
Date: Fri Aug 04 2006 - 13:02:36 ART

• Next message: lenny lim: "CAR"
• Previous message: ELDHO PAUL: "ospf neighbor command"
• Maybe in reply to: ELDHO PAUL: "ospf neighbor command"
• Next in thread: spycharlies@hotmail.com: "RE: ospf neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Can you paste your configs...

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
ELDHO PAUL
Sent: Friday, August 04, 2006 11:47 AM
To: ccielab@groupstudy.com
Subject: ospf neighbor command

Hi,

I changed the interface type of my ethernet interface to non broadcast using
the command ip ospf network non-broadcast.
Then I tried to configure neighbor with the neighboring router through this
interface using the command
neighbor 183.1.5.5
But it displays a message "OSPF: Neighbor command is allowed only on NBMA
and point-to-multipoint networks"

When i say show ip ospf int eth0/0
it shows the interface type as NON_BROADCAST.

Is it an expected behaviour?

Please advice.

Regards,
Eldho.

• Next message: lenny lim: "CAR"
• Previous message: ELDHO PAUL: "ospf neighbor command"
• Maybe in reply to: ELDHO PAUL: "ospf neighbor command"
• Next in thread: spycharlies@hotmail.com: "RE: ospf neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:56 ART