From: Mike O (mikeeo@msn.com)
Date: Wed Jun 14 2006 - 14:54:51 ART
I have a question that I thought I would throw out.
If you have a situation where some of your frame-relay interfaces are
allowed to have the ospf network type defined and then some not. Whats the
best way to configure that? For example say you have a hub and spoke with R1
as the hub as R4,5 and 6 as the spoke. R6 cannot use "ip ospf network" but
everyone else can. Do you just use neighbor? or better yet say you must use
network type on R4.
Is it always better to fall back and use the neighbor command when you can't
get anything else to work? considering you are allowed to use the neighbor
command in the given section.
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:32 ART