Re: OT : NAM Module reloading after software upgrade

From: kaelwyoung@netscape.net
Date: Wed May 03 2006 - 22:11:27 ART

• Next message: Mike O: "Lab checklist"
• Previous message: Nick Griffin: "Re: IEWB Lab4 Task 4.8 passive-interface command"
• Maybe in reply to: Jai Prakash: "OT : NAM Module reloading after software upgrade"
• Next in thread: Jai Prakash: "Re: OT : NAM Module reloading after software upgrade"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Jai,
     Did you also upgrade the maintenance image TO THE SAME VERSION ? What partition did you copy the sotware image?Is this a nam-1 or nam-2 ?
                                          Karl.
 
-----Original Message-----
From: Jai Prakash <jpjsr06@gmail.com>
To: ccielab@groupstudy.com
Sent: Wed, 3 May 2006 21:34:29 +0400
Subject: OT : NAM Module reloading after software upgrade

Hi Guys,

   I am soory to put this off topic at this site.But, I facing this problem
since last one week.
   I did software upgrade of NAM Module Application Image from 3.3 to
3.4for Netflow feature support.
   But, after upgrade the NAM module reloading countineously.

  It is giving error msg like " Module is not responding keeplive power
polling" .

  But, the same module works fine with Maintenance Image.This NAM Module is
installed into Cisco 6509 Switch.

Any help would be greatly appreciated.

Thanks in advance.

Best Regards,
Jai

• Next message: Mike O: "Lab checklist"
• Previous message: Nick Griffin: "Re: IEWB Lab4 Task 4.8 passive-interface command"
• Maybe in reply to: Jai Prakash: "OT : NAM Module reloading after software upgrade"
• Next in thread: Jai Prakash: "Re: OT : NAM Module reloading after software upgrade"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:20 ART