OT : NAM Module reloading after software upgrade

From: Jai Prakash (jpjsr06@gmail.com)
Date: Wed May 03 2006 - 14:34:29 ART

Next message: Vazman: "Re: Multicast questions"
Previous message: Beernink, William: "RE: IPSec VPN Tunnel not allowing large data transfer"
Next in thread: kaelwyoung@netscape.net: "Re: OT : NAM Module reloading after software upgrade"
Maybe reply: kaelwyoung@netscape.net: "Re: OT : NAM Module reloading after software upgrade"
Maybe reply: Jai Prakash: "Re: OT : NAM Module reloading after software upgrade"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Guys,

   I am soory to put this off topic at this site.But, I facing this problem
since last one week.
   I did software upgrade of NAM Module Application Image from 3.3 to
3.4for Netflow feature support.
   But, after upgrade the NAM module reloading countineously.

It is giving error msg like " Module is not responding keeplive power
polling" .

But, the same module works fine with Maintenance Image.This NAM Module is
installed into Cisco 6509 Switch.

Any help would be greatly appreciated.

Thanks in advance.

Best Regards,
Jai

Next message: Vazman: "Re: Multicast questions"
Previous message: Beernink, William: "RE: IPSec VPN Tunnel not allowing large data transfer"
Next in thread: kaelwyoung@netscape.net: "Re: OT : NAM Module reloading after software upgrade"
Maybe reply: kaelwyoung@netscape.net: "Re: OT : NAM Module reloading after software upgrade"
Maybe reply: Jai Prakash: "Re: OT : NAM Module reloading after software upgrade"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:20 ART