From: san (san.study@gmail.com)
Date: Tue May 02 2006 - 04:00:43 ART
Graham,
Couple of suggestions:
1) R11, S0/1 address change it to 170:100:10::254
2) At R11, have a IPV6 static route for pool address 2010 with next hop to
R6. (So that return traffic can go through from R11)
On 5/1/06, graham strydom <gstrydom74@ananzi.co.za> wrote:
>
> Hi All,
> I am struggling with IPV6 nat..just cannot seem to get it
> working...
> Setup as follows
> R3(F0/0-160.10.22.3/24) <-->
> (F0/0-160.10.22.6/24)R6(S0/1-170:100:10::1/64) <-->
> (S0/1-160:100:10::254/64) R11
>
> Config of Nat router as follows;
> Host R6
> !
> interface FastEthernet0/0
> ip address 160.10.22.6 255.255.255.0
> ipv6 nat
> !
> interface Serial0/1
> no ip address
> ipv6 address 170:100:10::1/64
> ipv6 nat prefix 2010:1111::/96
> ipv6 nat
> no dce-terminal-timing-enable
> !
> ipv6 nat v4v6 source 160.10.22.3 2010:1111::1
> ipv6 nat v6v4 source 170:100:10::254 160.10.22.8
>
> I added a IPV6 static route to R11 for 2010:1111::/96.
>
> Thanks
> Graham
>
> We are giving away Mugg & Bean Infinity cards to the value of R50 each to
> the first 30 Ananzi Dial-up sign-ups! Click here!:
>
> http://www.swiftsms.co.za/swiftT/track.asp?e=*em*&cid=113&u=8&tid=1062
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Thanks & Rgds SAN
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:20 ART