From: Reinhold Fischer (Reinhold.Fischer@gmx.net)
Date: Fri Apr 14 2006 - 16:56:33 GMT-3
Hi Pandi,
the command on R2 should be: rsh 10.1.1.1 /user R1 show ip route
Your config looks ok to me.
regards
reinhold
On Fri, Apr 14, 2006 at 09:35:58PM +0800, PANDI MOORTHY wrote:
> Hi Group,
>
> This is question relate to the RSH.
>
> The router R1 (10.1.1.1) and R2 (10.1.1.2) is on the same LAN. I am trying
> to get the routing table of R1 from R2 by using RSH.
>
> My config:
>
> R1:
> interface Ethernet0
> ip address 10.1.1.1 255.255.255.0
>
> ip rcmd rsh-enable
> ip rcmd remote-host R1 10.1.1.2 R2 enable
>
> R2:
>
> interface Ethernet0
> ip address 10.1.1.2 255.255.255.0
>
> ip rcmd rsh-enable
>
>
> >From R2: I try to run rsh
>
> "rsh 10.1.1.1 /R1 show ip route
>
> But the output I am getting is "permission denied"
>
> Is there any problem with my configuration?
>
> Regards.
> Pandi
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:57 GMT-3