From: Alexei Monastyrnyi (alexeim@orcsoftware.com)
Date: Tue Mar 21 2006 - 13:08:10 GMT-3
and this is on the root bridge indeed... forgot to mention that
thanks, Petr
on 21/03/2006 17:01 Alexei Monastyrnyi wrote:
> Hi.
> You can change STP timers per VLAN only (not per port), via global
> configuration commands
>
> SW1(config)#spanning-tree vlan 20 ?
> <1-1005> Spanning tree VLAN id
> forward-time Set a Spanning Tree FORWARD Interval
> hello-time Set a Spanning Tree HELLO Interval
> max-age Set a Spanning Tree MAX AGE Interval
> portfast Allow a change from blocking to forwarding
> priority Set a Spanning Tree Priority
> protocol Spanning tree protocol type
> <cr>
>
> A.
>
> on 21/03/2006 16:20 Evgeniy Voloshin wrote:
>> Hi Group,
>>
>> I have a little questions about STP - how I can reduce (learning and
>> listening) interval to 5 sec on some port, where I must to do it? In
>> global configuretion or on interface?
>>
>> I think that I must to change stp timers:
>> Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
>>
>> Hello to 1 sec, and Forward to 4 seconds - this is minimal value...
>>
>> Or I must change diameter on root bridge for this Vlan:
>> spanning-tree vlan XX root primary diameter 2-7
>> ?
>>
>> TIA!
>> ---
>> Yev.
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:39 GMT-3