From: Alexei Monastyrnyi (alexeim@orcsoftware.com)
Date: Tue Mar 21 2006 - 13:01:11 GMT-3
Hi.
You can change STP timers per VLAN only (not per port), via global
configuration commands
SW1(config)#spanning-tree vlan 20 ?
<1-1005> Spanning tree VLAN id
forward-time Set a Spanning Tree FORWARD Interval
hello-time Set a Spanning Tree HELLO Interval
max-age Set a Spanning Tree MAX AGE Interval
portfast Allow a change from blocking to forwarding
priority Set a Spanning Tree Priority
protocol Spanning tree protocol type
<cr>
A.
on 21/03/2006 16:20 Evgeniy Voloshin wrote:
> Hi Group,
>
> I have a little questions about STP - how I can reduce (learning and
> listening) interval to 5 sec on some port, where I must to do it? In
> global configuretion or on interface?
>
> I think that I must to change stp timers:
> Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
>
> Hello to 1 sec, and Forward to 4 seconds - this is minimal value...
>
> Or I must change diameter on root bridge for this Vlan:
> spanning-tree vlan XX root primary diameter 2-7
> ?
>
> TIA!
> ---
> Yev.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:39 GMT-3