From: Salzano, Mario Arthur Costa (mario.salzano@siemens.com)
Date: Wed Feb 08 2006 - 16:13:31 GMT-3
Hi Andy,
Try to use the commands: privilege interface level 5 ip and privilege
interface level 5 ip address. I did this way and it worked properly.
Tell me the result, ok?
Good Luck!
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Jens Petter Eikeland
Sent: Wednesday, February 08, 2006 1:58 PM
To: Anderson Mota Alves; ccielab@groupstudy.com
Subject: Re: Problems with privilege mode 5 commands
have you tried debuging this to see what is really happening. also you
should add the "privilege exec level 5 configure" command. also try
remove
the enable secret 5 and then test.. test with only the commands that are
needed to do the task... do the basics.. the config looks good to me, so
the
debug should tell you something more about it.
----- Original Message -----
From: "Anderson Mota Alves" <mota_anderson@hotmail.com>
To: <ccielab@groupstudy.com>
Sent: Wednesday, February 08, 2006 2:39 PM
Subject: Problems with privilege mode 5 commands
> Hi everyone, I have a requirement to make stated below and I made a
> resolution yesterday in my lab but the problem is that when I tried to
> assign an ip address to an interface logged in level 5 with the
commands
> I configured I can't make it, so I was wondering if someone here could
> help me out?Configure an user in privilege mode 5 with username user5
and
> password user5 and he must be able to do the following:
> Make an extended ping
> Configure interfaces
> Assign and remove IP address to an interface
> Save the config in NVRAM
> and turn off all the debugging in the router My resolution:username
> cisco5 privilege 5 password 0 cisco5
> enable secret level 5 5 $1$bkFU$AyQYwdii5.bP8n4hMKut6. privilege
> configure level 5 interface
> privilege configure level 5 ip address
> privilege exec level 5 ping
> privilege exec level 5 configure terminal
> privilege exec level 5 copy run start
> privilege exec level 5 undebug all line console 0
> login local Any comments are really appreciated !!! Regards,
> Andy
>
>
This archive was generated by hypermail 2.1.4 : Wed Mar 01 2006 - 11:28:17 GMT-3