From: Brent Foster (jbrentfoster@yahoo.com)
Date: Wed Feb 08 2006 - 15:18:54 GMT-3
You can send packets marked with ip TOS using extended
ping:
router1#ping
Protocol [ip]:
Target IP address: 10.20.20.200
Repeat count [5]:
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]: y
Source address or interface: 10.10.10.101
Type of service [0]: 5
Set DF bit in IP header? [no]:
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.20.20.200,
timeout is 2 seconds:
!!!!!
--- Jamie Caesar <jamie.caesar@gmail.com> wrote:
> You can verify on the router on the other side of
> the link with
> access-lists. Something like:
>
> access-list 101 permit ip any any prec 5
> access-list 101 permit ip any any dscp af11
> access-list 101 permit ip any any
>
> To see how many packets are being marked with
> precedence 5, or packets
> marked with dscp of af11.
>
> Also if you are using MQC, the "show policy
> interface" command should tell
> you on the local router how many packets were marked
> in a particular traffic
> class.
>
> Jamie
>
> On 2/8/06, TK ... <nuvo25@hotmail.com> wrote:
> >
> > Dear Group,
> >
> > I'm practicing packet marking with different
> method, such as PBR, and MQC.
> > However, I don't know how to test it to see
> whether it works? Is there any
> > debug command or show command that we can used to
> verify that the traffic
> > that match the configured criteria actually be
> marked with configured
> > marking
> > values?
> >
> > Thank you very much
> >
> > Jonathan...
> >
> >
>
This archive was generated by hypermail 2.1.4 : Wed Mar 01 2006 - 11:28:17 GMT-3