From: CCIEin2006 (ciscocciein2006@gmail.com)
Date: Thu Jan 19 2006 - 18:52:45 GMT-3
Anyone want to take a crack at these?
On 1/18/06, CCIEin2006 <ciscocciein2006@gmail.com> wrote:
>
> Hey guys,
>
> I noticed some interesting behavior on my lab routers when I load my
> initial configs. I was hoping each of these points could be addressed:
>
> 1. Encapsulation frame-relay IETF is automatically configured even though
> it is neither in my initial config nor the encapsulation type used on my
> frame relay switch. My frame relay switch is using default encapsulation of
> Cisco.
>
> 2. I am able to ping between a router configured with IETF and another
> router configured with Cisco encapsulation on the other end! I thought the
> two encapsulation types were incompatible?
>
> 3. Although the serial interfaces are enabled, IP's are configured, and
> PVC's are active, there are no dynamic mapping statements when I do a show
> frame-relay map. I thought the reason why you shut the interface even
before
> configuring frame-relay was to prevent this dynamic mapping?
>
> 4. The command frame-relay lmi-type cisco is automatically added to my
> configuration. I thought the default is to use LMI autosense?
>
> Thanks again!
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:49 GMT-3