From: Sheikh Rahman (Sheikh.Rahman@uk.didata.com)
Date: Fri Dec 16 2005 - 12:48:31 GMT-3
Hi
You may need to set the configuration-registry to 0X2101 , which will
make the flash writeable
HTH
Haf
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Joshua Li
Sent: 16 December 2005 06:47
To: ccielab@groupstudy.com
Subject: copy run flash in 2501 router falied
Hi,
I am trying to save my configuration file into NVRAM in a Cisco 2501
router.
But i get failed.
r1>sh ver
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-IS-L), Version 12.3(16)
...
16384K bytes of processor board System flash (Read ONLY)
..
r1#dir
Directory of flash:/
1 -rw- 16228680 <no date>
/c2500-is-l.123-16.bin
16777212 bytes total (548468 bytes free)
r1#copy run flash
**** NOTICE ****
Flash load helper v1.0
This process will accept the copy options and then terminate
the current system image to use the ROM based image for the copy.
Routing functionality will not be available during that time.
If you are logged in via telnet, this connection will terminate.
Users with console access can see the results of the copy operation.
---- ******** ----
Proceed? [confirm]
Destination filename [r1-confg]? xin
Erase flash: before copying? [confirm]n
*Mar 1 08:15:07.169: %SYS-5-RELOAD: Reload requested
%FLH: /running-config from 255.255.255.255 to flash ...
System flash directory:
File Length Name/status
1 16228680 /c2500-is-l.123-16.bin
[16228744 bytes used, 548472 available, 16777216 total]
Accessing file '/running-config' on 255.255.255.255... [failed]
%FLH: retry #1
%FLH: /running-config from 255.255.255.255 to flash ... (retry)
Any suggestions?
Thanks,
Joshua
This archive was generated by hypermail 2.1.4 : Mon Jan 09 2006 - 07:07:51 GMT-3