From: Daniel Berlinski (Daniel.Berlinski@telecom.co.nz)
Date: Tue Nov 15 2005 - 00:05:44 GMT-3
Hi everyone.
Will the following configs mark HTTP traffic coming from vlan 12 with precedence 5 and mark the remaining traffic with precedence 3?
--------------------------------------------------------------------------------------------------------------------------
mls qos
access-list 170 permit tcp any any eq www
class-map match-any HTTP
match access-group 170
class-map match-all VLAN12
match vlan 12
match class-map HTTP
policy-map MARKING
class VLAN12
set ip precedence 5
interface FastEthernet0/2
switchport access vlan 12
switchport mode access
mls qos cos 3
service-policy input MARKING
Rack1SW1#sh mls qos inter fa0/2
FastEthernet0/2
Attached policy-map for Ingress: MARKING
trust state: not trusted
trust mode: not trusted
COS override: dis
default COS: 3
DSCP Mutation Map: Default DSCP Mutation Map
trust device: none
-----------------------------------------------------------------------------------------------------------------------------------------------
From the documentation CD: "You cannot configure both port-based classification and VLAN-based classification at the same time. When you configure the match vlan vlan-list command, the class map becomes per-port per-VLAN based. If you configure a policy map that contains both port-based and VLAN-based class maps, the switch rejects the policy map when you attach it to an interface"
Will "mls qos cos 3" under the interface mark the remaining traffic with precedence 3?
Best regards
This communication, including any attachments, is confidential. If you are not the intended recipient, you should not read it - please contact me immediately, destroy it, and do not copy or use any part of this communication or disclose anything about it. Thank you. Please note that this communication does not designate an information system for the purposes of the Electronic Transactions Act 2002.
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:06 GMT-3