From: kevin gannon (kevin@gannons.net)
Date: Fri Nov 11 2005 - 05:02:00 GMT-3
If you have the "bandwidth" statement set correctly for the interface you
can do a "show interface" and there is a number of counters the one which
is nearest to a 5 minute average is "load" see below:
R4#show int s 0/0 | i load
reliability 255/255, txload 1/255, rxload 1/255
R4#
Its a fraction for tx and rx but handy.
Regards
kevin
On 11/11/05, Venkatesh Palani <kvpalani@gmail.com> wrote:
> HI Guys,
> I am nots uere if I am rite, I am just wondering if ther is a IOS command
> that woudl give the bandwidth utilization for an interface.
> Thank you,
> Venkatesh
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:06 GMT-3