From: kevin gannon (kevin@gannons.net)
Date: Fri Nov 11 2005 - 05:08:07 GMT-3
If at all possible try and limit the L2 domain to as small an area as possible.
In our own network we limit the L2 domain to a single data centre room
and in the offices each edge switch is L3 only. It saves a total melt down
when STP goes funny.
Not always possible but if you can you will sleep better.
Regards
Kevin
On 11/11/05, Schulz, Dave <DSchulz@dpsciences.com> wrote:
> Alex -
>
> By the question, I am assuming that you had loop issues...so, you may want to
> review your network and make sure that these switches are not cauing the loops
> (are you sure the edge switches are the issue...maybe some changes on the
> layout is needed). Also, review your VLAN layout (if you are using them).
> Other than replacing the switches, make sure that these switches run spanning
> tree, and set the priority high enough that they don't become a root. Just
> some thoughts, without knowing all the details of all the issues you are
> facing.
>
> Dave
>
> -----Original Message-----
> From: nobody@groupstudy.com
> To: ccielab@groupstudy.com
> Sent: 11/10/2005 10:20 PM
> Subject: loop prevention
>
> hi guys:
>
> What can I do to prevent loops in the core? My network edge switch
> consists of
> non-cisco switch,therefore I can't utilize loopguard,loopfilter... etc
> feature. So I must
> do in the core switch,any suggestion?Thanks for help.
>
>
> regards
> Alex
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:06 GMT-3