RE: getting T1/serial to NOT pass traffic in up/up condition

From: Vincent Mashburn (vmashburn@fedex.com)
Date: Tue Nov 08 2005 - 13:38:27 GMT-3

• Next message: Darren Browning: "RE: Ladies and Gentlemen, Please be upstanding for CCIE#15331"
• Previous message: Dave Temkin: "Re: Passed in Hong Kong at my first attempt."
• Maybe in reply to: Deep Ratan: "getting T1/serial to NOT pass traffic in up/up condition"
• Next in thread: kevin gannon: "Re: getting T1/serial to NOT pass traffic in up/up condition"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Try using passive-interface in router config mode.

Vince Mashburn
Engineer
901-263-5072
 CCNP, CCDA, Network +
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Deep Ratan
Sent: Tuesday, November 08, 2005 10:13 AM
To: Cisco certification
Subject: getting T1/serial to NOT pass traffic in up/up condition

Sorry if this is a newbie question. Is there any way to suddenly cause a
T1
port to stop passing traffic in an up/up condition? That is, can I
inejct
some command that will stop traffic from flowing but keep the interface
in
up/up state? If yes, will ISIS try to route traffic over an alternate
path
or will it continue pushing traffic over this disabled T1 because it is
in
up/up state?

thanks, Deep

• Next message: Darren Browning: "RE: Ladies and Gentlemen, Please be upstanding for CCIE#15331"
• Previous message: Dave Temkin: "Re: Passed in Hong Kong at my first attempt."
• Maybe in reply to: Deep Ratan: "getting T1/serial to NOT pass traffic in up/up condition"
• Next in thread: kevin gannon: "Re: getting T1/serial to NOT pass traffic in up/up condition"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:05 GMT-3