From: Daniel Berlinski (Daniel.Berlinski@telecom.co.nz)
Date: Sun Nov 06 2005 - 20:29:02 GMT-3
Hi Groupstudy
I'm trying to PBR traffic and set ip precedence 3 for all packets matched in the following configs:
route-map PBR permit 10
match interface FastEthernet0/1
set ip precedence flash
set ip next-hop 136.1.245.2
!
interface FastEthernet0/1
ip address 136.1.57.5 255.255.255.0
ip policy route-map PBR
duplex auto
speed auto
interface Serial0/0.245 multipoint
ip address 136.1.245.5 255.255.255.0
ip ospf message-digest-key 1 md5 CISCO
ip ospf network point-to-multipoint
ip ospf hello-interval 5
frame-relay map ip 136.1.245.2 502 broadcast
frame-relay map ip 136.1.245.4 504 broadcast
debug ip policy output shows that intended traffic is being PBRouted but on the other end the show interface precedence command does not increment precedence 3 matches. (I have enabled ip accounting precedence input on the next-hop router)
Have I messed up with something related to the order of operations? Is this the correct way of doing it?
Thanks a lot
This communication, including any attachments, is confidential. If you are not the intended recipient, you should not read it - please contact me immediately, destroy it, and do not copy or use any part of this communication or disclose anything about it. Thank you. Please note that this communication does not designate an information system for the purposes of the Electronic Transactions Act 2002.
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:05 GMT-3