From: mani poopal (mani_ccie@yahoo.com)
Date: Sun Oct 02 2005 - 00:56:41 GMT-3
Hi Group,
I have a small question regarding rate-limit command and ospf. Pls look at the following commands from cisco url.
QUESTION1:
=================================================================
interface Hssi0/0/0
description 45Mbps to R2
rate-limit input access-group 101 20000000 24000 32000 conform-action
set-prec-transmit 5 exceed-action set-prec-transmit 0
rate-limit input access-group 102 10000000 24000 32000 conform-action
set-prec-transmit 5 exceed-action drop
rate-limit input 8000000 16000 24000 conform-action set-prec-transmit 5 exceed-action
drop
================================================================
Now the last line is for any remaining traffic, instead of limiting remaining traffic, if I want to allow all the remaining traffic, what commands I need instead of the last line "rate-limit input 8000000 16000 24000 confrom-action set-prec-transmit 5 exceed-action drop or do I need any command.
QUESTION2:
In ospf what other methods are available to make ospf loopback appear as 24bit routes(assume mask of 24) other than using ip ospf network type to point to point or redistribute connected.)
thanks
Mani
---------------------------------
Yahoo! for Good
Click here to donate to the Hurricane Katrina relief effort.
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:49 GMT-3