From: Lileikis, Gary (gary.lileikis@unisys.com)
Date: Wed Sep 28 2005 - 23:56:28 GMT-3
It looks like the backup interface will work but you will need to use
the following:
map-class frame-relay frameclass
frame-relay end-to-end keepalive mode bidirectional
The above end-to-end keepalives will then need to be applied to both
sides of the PVC as follows:
interface Serial1/1.512 point-to-point
ip address 52.1.1.5 255.255.255.0
backup delay 3 3
backup interface BRI0/0
frame-relay class frameclass
frame-relay interface-dlci 512
class frameclass
Cheers...Gary
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
dusth@comcast.net
Sent: September 28, 2005 8:45 PM
To: ccielab@groupstudy.com
Subject: ISDN backup interface command
Hi All, I do not have access to the lab so I have simple question to you
all. If I have physcial frame-relay interface with only one pvc active,
does the "backup interface bri0/0" command work, or I have to use
snap-shot routing if I'm not allowd to use dialer-watch or ip ospf
demand-circuit?
Thanks,Dustin
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:17 GMT-3