From: Tim (ccie2be@nyc.rr.com)
Date: Sun Sep 18 2005 - 14:31:59 GMT-3
Imal,
Have a look at this link.
This link appears to address your question very directly - see the usage
guidance section.
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225sec/3550cr/cl
i1.htm#wp1861670
But, as I said before, if possible, verify the accuracy of the doc's.
DO NOT BELIEVE ANYTHING YOU READ IN THE DOC'S UNLESS YOU PERSONALLY VERIFY
IT'S TRUTH.
HTH, Tim
_____
From: Imal kalutotage [mailto:imal.kalutotage@gmail.com]
Sent: Sunday, September 18, 2005 2:02 AM
To: Tim
Subject: Re: mls QoS question
Hi Tim & the Group,
I also observed this message when ever I try to enable mls qos.
My question is, this..
Say we have flow control enable for one port & rest is without flow
control..
But the message we get is
Rack1SW2(config)#mls qos
QoS: ensure flow-control on all interfaces are OFF for proper operation.
So does that means even if the flow control is ON for one port, the mls qos
will not
function properly..?
Cheers,
Imal
On 9/18/05, Tim <ccie2be@nyc.rr.com> wrote:
Jeff,
By default, flow control isn't an issue when it comes to QoS. However, in
the lab, you should ALWAYS double check to see whether non-default settings
have been pre-configured.
Remember part of the challenge of passing the lab is being able to
troubleshoot problems while under time pressure. So, don't assume any
setting is at its default.
HTH, Tim
-----Original Message-----
From: nobody@groupstudy.com <mailto:nobody@groupstudy.com>
[mailto:nobody@groupstudy.com] On Behalf Of
Ryan, Jeff
Sent: Saturday, September 17, 2005 9:42 PM
To: ccielab@groupstudy.com <mailto:ccielab@groupstudy.com>
Subject: mls QoS question
All, when enabling QoS on the 3550, I always get the following:
Rack1SW2(config)#mls qos
QoS: ensure flow-control on all interfaces are OFF for proper operation.
Does anyone go under the interfaces in question and disable flow control
as standard?
Thanks,
Jeff
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:15 GMT-3