RE: eigrp timer!

From: Alvarez, Rolando [NCSUS] (RAlvare5@NCSUS.JNJ.COM)
Date: Wed Sep 07 2005 - 13:14:13 GMT-3

• Next message: Private Ryan: "What is difference about "distribute-list out" and route-map ?"
• Previous message: simon hart: "RE: eigrp timer!"
• Maybe in reply to: KSGoh: "eigrp timer!"
• Next in thread: simon hart: "RE: eigrp timer!"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

How about 'show ip eigrp neighbors'?

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of simon
hart
Sent: Wednesday, September 07, 2005 12:02 PM
To: KSGoh; Cisco certification
Subject: RE: eigrp timer!

Hi,

I do not believe there is a command to show either the hello-interval or the
hold time.

Now the IOS will default hello-interval to 60 seconds on low speed NBMA (T1
or below), other media will be 5 seconds.

Anything other than this will have to eplicitly configured under the
interface i.e.

ip eigrp hello-interval 180

therefore if you want to determine whether the hello interval is not the
default then do a sh run int xxx to see what is configured.

Hold time is going to be 3 times the hello interval (unless explicitly
configured otherwise)

Simon

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of KSGoh
Sent: 07 September 2005 13:08
To: Cisco certification
Subject: eigrp timer!

i'm looking for command to show me the hello and hold-down timer for eigrp
on
each interface..

anybody here can help ?

• Next message: Private Ryan: "What is difference about "distribute-list out" and route-map ?"
• Previous message: simon hart: "RE: eigrp timer!"
• Maybe in reply to: KSGoh: "eigrp timer!"
• Next in thread: simon hart: "RE: eigrp timer!"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:14 GMT-3