From: simon hart (simon@harttel.com)
Date: Wed Sep 07 2005 - 16:07:22 GMT-3
It does not show the hello interval. It will show the hold time, but as a
countdown from the previous hello. Therefore if you issue the command
several times, you can hazard a guess at the hello and hold
Rack1R5#sh ip eigrp neighbors
IP-EIGRP neighbors for process 100
H Address Interface Hold Uptime SRTT RTO Q Seq
Type
(sec) (ms) Cnt Num
1 148.1.35.3 Se0/0 13 12:34:07 149 894 0 3
0 148.1.57.7 Et0/0 10 12:35:50 378 2268 0 7
Simon
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Alvarez, Rolando [NCSUS]
Sent: 07 September 2005 17:14
To: 'simon hart'; KSGoh; Cisco certification
Subject: RE: eigrp timer!
How about 'show ip eigrp neighbors'?
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of simon
hart
Sent: Wednesday, September 07, 2005 12:02 PM
To: KSGoh; Cisco certification
Subject: RE: eigrp timer!
Hi,
I do not believe there is a command to show either the hello-interval or the
hold time.
Now the IOS will default hello-interval to 60 seconds on low speed NBMA (T1
or below), other media will be 5 seconds.
Anything other than this will have to eplicitly configured under the
interface i.e.
ip eigrp hello-interval 180
therefore if you want to determine whether the hello interval is not the
default then do a sh run int xxx to see what is configured.
Hold time is going to be 3 times the hello interval (unless explicitly
configured otherwise)
Simon
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of KSGoh
Sent: 07 September 2005 13:08
To: Cisco certification
Subject: eigrp timer!
i'm looking for command to show me the hello and hold-down timer for eigrp
on
each interface..
anybody here can help ?
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:14 GMT-3