From: Andy Tang (andytang88@gmail.com)
Date: Tue Jun 28 2005 - 01:13:28 GMT-3
Hi Brian,
Can I boot the enterprise plus image c2600-js-mz.122-15.T16.bin from TFTP
to the 2620 64MD/16F via the "tftpdnld -r" command in rommon?
Thanks & regards,
Andy
On 5/25/05, Brian McGahan <bmcgahan@internetworkexpert.com> wrote:
>
> You can boot the 2600XM enterprise plus image from TFTP to the 2610 or
> 2611 via the "tftpdnld -r" command in rommon.
>
> HTH,
>
> Brian McGahan, CCIE #8593
> bmcgahan@internetworkexpert.com
>
> Internetwork Expert, Inc.
> http://www.InternetworkExpert.com
> Toll Free: 877-224-8987 x 705
> Outside US: 775-826-4344 x 705
> 24/7 Support: http://forum.internetworkexpert.com
> Live Chat: http://www.internetworkexpert.com/chat/
>
>
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
> Of
> > Chad Hintz
> > Sent: Tuesday, May 24, 2005 7:11 AM
> > To: Mathew; 'Cisco certification'
> > Subject: Re: Command "ipv6 ospf" on 2600 with IOS 12.2(15)T15
> >
> > The 2610 does not support this feature, you need a 2620 or 21 to use
> > ospfv3.
> >
> > HTH,
> >
> > Chad
> >
> >
> > Hi Team
> >
> > Does anybody know why I can not enable IPV6 OSPF on 2600 with IOS ver
> > 12.2(15)T15?
> >
> > Even after configuring "ipv6 unicast-routing" and "ipv6 enable" under
> the
> > interface, I do not see
> >
> > a OSPF option.
> >
> > Does anybody know why it is so?
> >
> > R2(config-if)#ipv6 ?
> > IPv6 interface subcommands:
> > address Configure IPv6 address on interface
> > cef Cisco Express Forwarding for IPv6
> > enable Enable IPv6 on interface
> > mtu Set IPv6 Maximum Transmission Unit
> > nat Enable IPv6 NAT on interface
> > nd IPv6 interface Neighbor Discovery subcommands
> > redirects Enable sending of ICMP Redirect messages
> > rip Configure RIP routing protocol
> > router IPv6 Router interface commands
> > traffic-filter Access control list for packets
> > unnumbered Preferred interface for source address selection
> > verify Enable per packet validation
> >
> > R2(config-if)#ipv6 ro
> > R2(config-if)#ipv6 router ?
> > isis IS-IS Routing for IPv6
> >
> > R2(config-if)#ipv6 router
> > R2(config-if)#do sho ver
> > Cisco Internetwork Operating System Software
> > IOS (tm) C2600 Software (C2600-J1S3-M), Version 12.2(15)T15, RELEASE
> > SOFTWARE (fc1)
> > Technical Support: http://www.cisco.com/techsupport
> > Copyright (c) 1986-2005 by cisco Systems, Inc.
> > Compiled Thu 03-Mar-05 03:28 by hqluong
> > Image text-base: 0x80008098, data-base: 0x81960D40
> >
> > ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
> > ROM: C2600 Software (C2600-J1S3-M), Version 12.2(15)T15, RELEASE
> SOFTWARE
> > (fc1)
> >
> > R2 uptime is 47 minutes
> > System returned to ROM by power-on
> > System image file is "flash:c2600-j1s3-mz.122-15.T15.bin"
> >
> > cisco 2610 (MPC860) processor (revision 0x203) with 61440K/4096K bytes
> of
> > memory.
> > Processor board ID JAD05090GQQ (1222274526)
> > M860 processor: part number 0, mask 49
> > Bridging software.
> > X.25 software, Version 3.0.0.
> > TN3270 Emulation software.
> > 1 Ethernet/IEEE 802.3 interface(s)
> > 2 Serial(sync/async) network interface(s)
> > 16 terminal line(s)
> > 32K bytes of non-volatile configuration memory.
> > 16384K bytes of processor board System flash (Read/Write)
> >
> > Configuration register is 0x2102
> >
> > R2(config-if)#
> >
> >
> _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam? Yahoo! Mail has the best spam protection around
> > http://mail.yahoo.com
> >
> >
> _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:44 GMT-3