From: Sean C (Upp_and_Upp@hotmail.com)
Date: Sat Jun 04 2005 - 21:38:06 GMT-3
Hi San,
Ahh, ok, the exact opposite. The original task "not to initiate the dialer
watch process untill all the routing protocols settle down after the router
boot up" isn't solved by using 'delay route-check initial time'.
Per the CD: The Dialer Watch feature is triggered only when the primary
route is removed from the routing table. If the primary link fails to come
up during initial startup of the router, the route is never added to the
routing table and will not be watched.
So, for this task, the, using 'delay route-check' won't solve the issue. In
fact, nothing is needed since it's the default.
But if the task wanted the router's dialer watch to initiate a call even at
the initial boot-up if the route isn't in the route-table, then you would
use 'delay route-check initial time' syntax.
Hope this makes sense,
Sean
----- Original Message -----
From: "san" <san.study@gmail.com>
To: "Sean C" <Upp_and_Upp@hotmail.com>
Cc: "GroupStudy" <ccielab@groupstudy.com>
Sent: Saturday, June 04, 2005 8:16 PM
Subject: Re: trying to recollect dialer watch command
> After 1.5 hrs of search for 1 cmd....Here is the valuable cmd.
>
> dialer watch-list group-number {ip ip-address address-mask | delay
> route-check initial time}
>
> /SAN
>
>
> On 6/4/05, Sean C <Upp_and_Upp@hotmail.com> wrote:
>> Hi San,
>>
>> According to the 12.3 Master-command list, there's only 4 dialer watch
>> commands, so you think it would have to be one of the 4.
>>
>> I would think 'dialer watch-list delay' but this doesn't wait for any
>> routing-protocol to be 'synched' before being enabled like you are
>> looking
>> for. I thought I remember a similar question from one of the IEWBs
>> (perhaps
>> the new Volume 2?) but I thought it just asked to wait some set of time,
>> not
>> specifically for the routing protocol(s) to be synched.
>>
>> Sean
>> > ----- Original Message -----
>> > From: "san" <san.study@gmail.com>
>> > To: "Group Study" <ccielab@groupstudy.com>
>> > Sent: Saturday, June 04, 2005 7:25 PM
>> > Subject: trying to recollect dialer watch command
>> >
>> >
>> >> Hi ,
>> >>
>> >> I am trying to recollect a command that is used for "not to initiate
>> >> the dialer watch process untill all the routing protocols settle down
>> >> after the router boot up".
>> >>
>> >> This command is to make sure, that watched route already exists in
>> >> routing table, before looking for non-exists of same routes.
>> >>
>> >> I tried looking in Doc, but could not get it my searches.
>> >>
>> >> If anyone remembers, help me.
>> >>
>> >> /SAN
>> >>
>> >> _______________________________________________________________________
>> >> Subscription information may be found at:
>> >> http://www.groupstudy.com/list/CCIELab.html
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3