From: san (san.study@gmail.com)
Date: Sat Jun 04 2005 - 21:16:46 GMT-3
After 1.5 hrs of search for 1 cmd....Here is the valuable cmd.
dialer watch-list group-number {ip ip-address address-mask | delay
route-check initial time}
/SAN
On 6/4/05, Sean C <Upp_and_Upp@hotmail.com> wrote:
> Hi San,
>
> According to the 12.3 Master-command list, there's only 4 dialer watch
> commands, so you think it would have to be one of the 4.
>
> I would think 'dialer watch-list delay' but this doesn't wait for any
> routing-protocol to be 'synched' before being enabled like you are looking
> for. I thought I remember a similar question from one of the IEWBs (perhaps
> the new Volume 2?) but I thought it just asked to wait some set of time, not
> specifically for the routing protocol(s) to be synched.
>
> Sean
> > ----- Original Message -----
> > From: "san" <san.study@gmail.com>
> > To: "Group Study" <ccielab@groupstudy.com>
> > Sent: Saturday, June 04, 2005 7:25 PM
> > Subject: trying to recollect dialer watch command
> >
> >
> >> Hi ,
> >>
> >> I am trying to recollect a command that is used for "not to initiate
> >> the dialer watch process untill all the routing protocols settle down
> >> after the router boot up".
> >>
> >> This command is to make sure, that watched route already exists in
> >> routing table, before looking for non-exists of same routes.
> >>
> >> I tried looking in Doc, but could not get it my searches.
> >>
> >> If anyone remembers, help me.
> >>
> >> /SAN
> >>
> >> _______________________________________________________________________
> >> Subscription information may be found at:
> >> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3