From: Sean C (Upp_and_Upp@hotmail.com)
Date: Sat Jun 04 2005 - 21:08:59 GMT-3
Hi San,
According to the 12.3 Master-command list, there's only 4 dialer watch
commands, so you think it would have to be one of the 4.
I would think 'dialer watch-list delay' but this doesn't wait for any
routing-protocol to be 'synched' before being enabled like you are looking
for. I thought I remember a similar question from one of the IEWBs (perhaps
the new Volume 2?) but I thought it just asked to wait some set of time, not
specifically for the routing protocol(s) to be synched.
Sean
> ----- Original Message -----
> From: "san" <san.study@gmail.com>
> To: "Group Study" <ccielab@groupstudy.com>
> Sent: Saturday, June 04, 2005 7:25 PM
> Subject: trying to recollect dialer watch command
>
>
>> Hi ,
>>
>> I am trying to recollect a command that is used for "not to initiate
>> the dialer watch process untill all the routing protocols settle down
>> after the router boot up".
>>
>> This command is to make sure, that watched route already exists in
>> routing table, before looking for non-exists of same routes.
>>
>> I tried looking in Doc, but could not get it my searches.
>>
>> If anyone remembers, help me.
>>
>> /SAN
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3