From: marvin greenlee (marvin@ccbootcamp.com)
Date: Tue May 10 2005 - 18:28:41 GMT-3
Changing the LMI type on the interface will bring it down.
Marvin Greenlee, CCIE#12237, CCSI# 30483
Network Learning Inc
marvin@ccbootcamp.com
www.ccbootcamp.com (Cisco Training)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Golia, Jeff
Sent: Tuesday, May 10, 2005 2:20 PM
To: Group Study (E-mail)
Subject: test backup interface config [bcc][faked-from]
Importance: Low
Hello,
How can I test a backup interface, when using BRI as a backup to FR.
Obviously administratively shutting down the serial int is out. In the lab,
I will not be able to physically unhook a cable. Also, I will not be able
to access the Frame Switch to admin shut down the remote end.
Issuing "no encap frame" on the serial int has the undesired effect of
removing all frame config (Map statements, etc)
How would you test such a backup config?
thanks
Jeff Golia, CCNP MCSE
Network Administrator
Transworld Port and Distribution Services
Wilmington, Delaware
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:57 GMT-3