From: JC - (jice466@hotmail.com)
Date: Wed May 11 2005 - 08:33:45 GMT-3
Hi,
One way to test that, is to backup a FR subinterface. Then administratively
shuting the physical intf will put in a protocol down state the subintf due
to loss of LMI.
Backup should then comes up.
Rgds,
Jici
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
>Golia, Jeff
>Sent: Tuesday, May 10, 2005 2:20 PM
>To: Group Study (E-mail)
>Subject: test backup interface config [bcc][faked-from]
>Importance: Low
>
>Hello,
>
>How can I test a backup interface, when using BRI as a backup to FR.
>
>Obviously administratively shutting down the serial int is out. In the
>lab,
>I will not be able to physically unhook a cable. Also, I will not be able
>to access the Frame Switch to admin shut down the remote end.
>
>Issuing "no encap frame" on the serial int has the undesired effect of
>removing all frame config (Map statements, etc)
>
>How would you test such a backup config?
>
>thanks
>
>Jeff Golia, CCNP MCSE
>Network Administrator
>Transworld Port and Distribution Services
>Wilmington, Delaware
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:57 GMT-3