Re: 3550 Port Configuration for Voice

From: gladston@br.ibm.com
Date: Wed Feb 23 2005 - 22:26:04 GMT-3


Thanks

=========
quoted
Please don't comback and say
we are really doing trunk etc...I know that.
=========

I just said that this morning to a workmate :)

------------------------------------------------------------------
Alaerte

Balaji Siva <bsivasub@gmail.com>
02/23/2005 05:20 PM
Please respond to
Balaji Siva

To
Alaerte Gladston Vidali/Brazil/IBM@IBMBR
cc
ccielab@groupstudy.com
Subject
Re: 3550 Port Configuration for Voice

You would do switchport mode access and configure access vlan and voice
vlan.

SwitchB(config-if)#switchport mode access
SwitchB(config-if)#switchport access vlan 10
SwitchB(config-if)#switchport voice vlan 100

Trunk "mode" config is not necessary. Please don't comback and say
we are really doing trunk etc...I know that. but from configuration
point of view, you don't have to put the port into trunk mode.

hth
Balaji

On Wed, 23 Feb 2005 03:50:35 -0500, gladston@br.ibm.com
<gladston@br.ibm.com> wrote:
> Sorry this topic again.
> From a discussion with a studygroup, there are different points of view
if a interface connected to a Cisco IPPhone should be kept in switchport
mode dynamic or switchport mode trunk.
>
> One said if using switchport voice vlan vlan-id is is not necessary to
trunk. I must confess I am lost after nothing getting a point from Wendell
and Catalyst QoS about this.
>
> I am aware voice is over on R&S.
>
> Any post appreciated.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html



This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:25 GMT-3