From: Arif Rahman (arahman@cisco.com)
Date: Fri Feb 11 2005 - 01:52:02 GMT-3
Hi
thank you for reply. I am trying to solve the question which asked to sniff
packets from vlan that has member on two switches. Now the question is how
to configure the switch which is connected to both sniffer (like IDS
sensor) and traffic source.
thank you
At 11:34 PM 2/10/2005 -0500, Balaji Siva wrote:
>you can't configure RSPAN on same box. Hw can't do recursive spaning
>packets.
>
>
>
>On Thu, 10 Feb 2005 20:27:54 -0800, Arif Rahman <arahman@cisco.com> wrote:
> > Hi
> > I have only one switch and have following configuration. I am trying to
> > configure RSPAN. But for some reason it is not working.
> >
> > monitor session 1 destination interface Fa0/3
> > monitor session 1 source remote vlan 233
> > monitor session 2 source vlan 11 rx
> > monitor session 2 destination remote vlan 233 reflector-port Fa0/12
> >
> > I noticed reflector-port is getting lot of packets but not f0/3.
> >
> > If I configure SPAN like below then it works fine. f0/3 as well as IDS get
> > the packets.
> >
> > monitor session 1 destination interface Fa0/3
> > monitor session 1 source vlan 11 rx
> >
> > Any idea what could be wrong?
> >
> > thank you
This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:19 GMT-3