From: Balaji Siva (bsivasub@gmail.com)
Date: Fri Feb 11 2005 - 01:34:13 GMT-3
you can't configure RSPAN on same box. Hw can't do recursive spaning packets.
On Thu, 10 Feb 2005 20:27:54 -0800, Arif Rahman <arahman@cisco.com> wrote:
> Hi
> I have only one switch and have following configuration. I am trying to
> configure RSPAN. But for some reason it is not working.
>
> monitor session 1 destination interface Fa0/3
> monitor session 1 source remote vlan 233
> monitor session 2 source vlan 11 rx
> monitor session 2 destination remote vlan 233 reflector-port Fa0/12
>
> I noticed reflector-port is getting lot of packets but not f0/3.
>
> If I configure SPAN like below then it works fine. f0/3 as well as IDS get
> the packets.
>
> monitor session 1 destination interface Fa0/3
> monitor session 1 source vlan 11 rx
>
> Any idea what could be wrong?
>
> thank you
This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:19 GMT-3