RSPAN question

From: Arif Rahman (arahman@cisco.com)
Date: Fri Feb 11 2005 - 01:27:54 GMT-3

• Next message: Balaji Siva: "Re: RSPAN question"
• Previous message: Scott Morris: "RE: Quality of Cisco Documentation"
• Next in thread: Balaji Siva: "Re: RSPAN question"
• Maybe reply: Balaji Siva: "Re: RSPAN question"
• Maybe reply: Arif Rahman: "Re: RSPAN question"
• Maybe reply: Balaji Siva: "Re: RSPAN question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi
I have only one switch and have following configuration. I am trying to
configure RSPAN. But for some reason it is not working.

monitor session 1 destination interface Fa0/3
monitor session 1 source remote vlan 233
monitor session 2 source vlan 11 rx
monitor session 2 destination remote vlan 233 reflector-port Fa0/12

I noticed reflector-port is getting lot of packets but not f0/3.

If I configure SPAN like below then it works fine. f0/3 as well as IDS get
the packets.

monitor session 1 destination interface Fa0/3
monitor session 1 source vlan 11 rx

Any idea what could be wrong?

thank you

• Next message: Balaji Siva: "Re: RSPAN question"
• Previous message: Scott Morris: "RE: Quality of Cisco Documentation"
• Next in thread: Balaji Siva: "Re: RSPAN question"
• Maybe reply: Balaji Siva: "Re: RSPAN question"
• Maybe reply: Arif Rahman: "Re: RSPAN question"
• Maybe reply: Balaji Siva: "Re: RSPAN question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:19 GMT-3